Home Automation Domotica Forum Europe, Bwired Forum

I did a bit of further research on the X10 (obviously because X10 is more popular in Australia than PLCBus) as I figured my problem of separate circuits must have been raised before. I read that so long as all the circuits are wired onto the same phase (which they are), then the signals should get a...

Thanks for the advice guys, House is definitely single phase only. The electrician knows nothing about PLCbus and yes only followed the wiring diagram. I have yet to ask about connecting to the light circuit, but should find out today. I'm thinking that the same problem would occur here with x10 als...

Thanks for the links homeVisu, your Java controller looks really good, and these manuals are a little more detailed so thanks! by Digit » Thu Dec 16, 2010 8:50 am That could very well be the problem! If it's not too much work, try to get both on the same circuit and try again. Um that's kinda illega...

Hi Digit, No I did try and set the addresses and it didn't work, so I thought I must have been doing it wrong....seems I haven't, and it just doesn't work. When I send the addresses the interface buzzes so it is receiving the commands, unfortunately just the modules themselves aren't responding. Hou...

Thanks Digit, The modules that I have were purchased from 10hk.com and I've recently found out that they may be slightly different firmware to the ones purchased in the Netherlands (I'm in Australia). They came with brief standard instructions which are used for all the various modules. In the instr...

I have some 2 load modules installed on lights 2264D which are controlled independently by two momentary switches. How do I program these 2 load modules? There is only one reset button on the module itself, how do I program the second address? eg I want house code 1 to be H1 and house code 2 to be H...