Home Automation Domotica Forum Europe, Bwired Forum

Thanks for your explanation. I saw that nodo firmware is different from yours but it at least uses the same commands. My thoughts till now were that the Remeha takes care of the calculation when sending in a room temperatur (there is a setting: control heating automatic/based on outside/temperatur/b...

As I wrote, I would like to send the current temperature, measured by a ZigBee Sensor in the Living room (as far as I understood MsgId 24) as well as a temperature sensor I can adjust via a tablet (MsgId 16). I had a look on http://otgw.tclcode.com/firmware.html#operation but did not found commands ...

Hi, I am pretty new to this forum and Opentherm. I received my OPTG from Nodo last week and installed it successfully at my Calenta ACE 25 (connected to the R-BUS in the front flap). The OTGW is not connected to any Thermostat as I have to put complete new wires to the living room (Bridge the contac...