Home Automation Domotica Forum Europe, Bwired Forum

@ DanD, Seems all post need first to be approved... this slowes things down... Anyhow writing the flow down, comparing, running now with 2 changes : CC1011 at 4 mhz SPI clock instead of 125khz (I couldn't figure out why it is set so low..) Under de ~ 6 mhz you don't need to take any additional care ...

Dan, Thanks so far.

I "read" the whole firmware including lib's etc.
Quite "easy" to follow, now writing out the flow chart.

Sending part is working with 0.8Dan, with 0.92 i doubt..

Running a Diff now to check the differences.

Keep you all posted...

Meantime found a picture of the HGI80 inside... will dive in to this.

@ Dan, No need for apologies :) just wondering, now running "your" firmware, ( called it 0.8Dan :)) Seems that I have now many "new＂errors. Not sure but did you put additinal logs on ? The "external_sensor" i never see before. pay load size, see before. But when i am looking...

Oh and my setup is :

HR80 V2.04 x 4 (soon 5 or 6)
HRB91 relay on the floorheating pump

first color screen + internet gateway

Raspbery pi2+ with own made RFbee (arduino mini Pro + CC1101 + FT chip).

The Osscal part I also figerd out .. I had a small programm to minimize the error, but by changing the osscal value nothing happend. Then indeed reading the datasheet, osscal is only for the internal oscilator. Could you see, with lowering the baudrate, the error's decrease ? By picking 74880, the p...

Sorry typo, 0.9alpha, same you also use. I only compiled it with Arduino, reading the post, not sure if this impliment all changes..? Also understand that Daan updated the orignale one, (can also see it on the date) but, version number is still 0.8 ? Until know running ok : Total error log in Domoti...

Sorry.. typo... 0.9alpha, the one from fredh, which you also use.

I understand that orginal version now also is updated (DanD), but Dan you forgot to udpdate the version number ? it still say 0.8 (?)

Transmitting, in my case also doesn't work with 0.9 alpha, does anyone have that working ?

Hi, Thanks for the great work ! I have next setup : Living room floor heating, Pump, of the floorheating, is switch on/off with BDR91 (set up as valvue controller), temp measurment is the ATC928G2000. Hallway and other rooms have a HR80 ( 4 x times), in one room a honenywell round is used as temp se...