How to install a MS13

Forum about Xanura, Eaton Holec and Marmitek and other brand X10 and A10 devices.
Post Reply
Wim2008
Advanced Member
Advanced Member
Posts: 718
Joined: Wed Aug 12, 2009 1:42 pm
Location: Eindhoven, Netherlands

How to install a MS13

Post by Wim2008 »

I have update Windows XP to W7. I have also reinstalled a new HS2.
Now I have several MS13 devices which I don't know how to connect with HS2.
Has someone a short manual for me?

BR Wim :)
mrqnapper
Member
Member
Posts: 234
Joined: Sat Jun 25, 2011 1:08 pm

Re: How to install a MS13

Post by mrqnapper »

It's not that difficult as far as I remember. I assume you have the RFXcom plugin and RFXcom receiver/transmitter in use?

If so,
just create an new device, with settings:
Name:
Room
Floor:
Device type: MS13 (hawkeye )
Have a letter code say F 3

Save this and go to the RFXcom tab.
Choose X10config
Now look for F (or any other letter you picked for your device) and change the "process" settings to Status Only"
save and have a look at the status update to find out if the device is noticed by Homeseer. That's it.



Wiechert
Wim2008
Advanced Member
Advanced Member
Posts: 718
Joined: Wed Aug 12, 2009 1:42 pm
Location: Eindhoven, Netherlands

Re: How to install a MS13

Post by Wim2008 »

Thanks a lot.
I was looking in the RFXcom tab for creating the new device and couldn't find the right device type there.

B.R. Wim :)
Wim2008
Advanced Member
Advanced Member
Posts: 718
Joined: Wed Aug 12, 2009 1:42 pm
Location: Eindhoven, Netherlands

Re: How to install a MS13

Post by Wim2008 »

I think that you also need to add F 2 on the same way for the light-dark sensor of the same device.

B.R. Wim :)
Post Reply

Return to “X10, A10 Xanura Marmitek Forum”