Atlantis Loria 6000 Inventer

This Forum is about the Opentherm gateway (OTG) from Schelte

Moderator: hvxl

Atlantis Loria 6000 Inventer

Postby minocz73 » Mon Aug 19, 2019 10:33 pm

Good day,
Can you please help me with the connection of the heat pump Atlantis Loria 6000 Inventer, firmware v. 27. Reading the values is OK, but the command driver does not work, only the OT command works the other commands are ignored. The heat pump motherboard is Honeywell and the room thermostat is UA55... Please help me..
Thank you Mark
minocz73
Starting Member
Starting Member
 
Posts: 3
Joined: August 2019

Re: Atlantis Loria 6000 Inventer

Postby hvxl » Mon Aug 26, 2019 4:14 pm

If the OT command works, then what you call "the command driver" seems to be working at least partly.

So you claim that PR=A doesn't report the current version, and GW=R doesn't reset the OTGW, but OT=33 correctly sets the outside temperature? That would be very strange. Please show a log when you try such commands.

Of course there are some commands that have no effect if your equipment doesn't support that functionality, but there should definitely be other commands than the OT command that do something.
Schelte
hvxl
Senior Member
Senior Member
 
Posts: 1223
Joined: June 2010


Return to Opentherm Gateway Forum

Who is online

Users browsing this forum: No registered users and 1 guest