OTGW led's off and Error 03
Posted: Thu Oct 17, 2019 10:20 am
Hi all. I have recently bought the OTGW from NodoShop, installed it between my new OT+ boiler and OT+ capable thermostat, but experiencing some issues.
Firstly I installed the OTGW with last firmware version flashed (from Nodo), activated the OTMonitor on my PC connected wirelessly through the ESP8266, and all worked as expected.
After a few hours I started to have Error03, firstly not so often, than more and more frequently. I changed the VR to 2, and the the Errors started to be less frequent.
After a few minutes the leds on the board switched completely off, although the communication was working.
As I have to monitor the OTGW through Domoticz, I disconnected the OTMonitor and, to see if all was working, I connected through a Telnet. I started to see all messages but, after a few minutes, only Txxxxxxxx and Error 03. setting the OTGW in Monitor mode (GW=0), the errors disappeared (not completely, but not so frequent).
Switching off and on the OTGW sometimes changes the things but, after a few hours, the behaviour is always the same.
I would like to understand if LEDs switch off is a normal behaviour and if someone have had the same issues, and solved them.
Thank you in advance.
Firstly I installed the OTGW with last firmware version flashed (from Nodo), activated the OTMonitor on my PC connected wirelessly through the ESP8266, and all worked as expected.
After a few hours I started to have Error03, firstly not so often, than more and more frequently. I changed the VR to 2, and the the Errors started to be less frequent.
After a few minutes the leds on the board switched completely off, although the communication was working.
As I have to monitor the OTGW through Domoticz, I disconnected the OTMonitor and, to see if all was working, I connected through a Telnet. I started to see all messages but, after a few minutes, only Txxxxxxxx and Error 03. setting the OTGW in Monitor mode (GW=0), the errors disappeared (not completely, but not so frequent).
Switching off and on the OTGW sometimes changes the things but, after a few hours, the behaviour is always the same.
I would like to understand if LEDs switch off is a normal behaviour and if someone have had the same issues, and solved them.
Thank you in advance.