Rooting Toon (or boxx)

Everything about rooting Toons 1 and 2.

Moderators: marcelr, TheHogNL, Toonz

TheS4ndm4n
Starting Member
Starting Member
Posts: 3
Joined: Sun Jun 12, 2022 7:40 pm

Re: Rooting Toon (or boxx)

Post by TheS4ndm4n »

Well, still managed to brick it :shock:
The loop was still going in the serial console. Figured out it was a botched busybox installation.
In my lack of knowledge, I deleted busybox from the Toon to fix it.
and now linux wont boot anymore because it doesnt recognise any commands in the init.d

Managed to run toonrecovery from the Pi and get into the serial console. But it stops doing anything after this:

Code: Select all

IP-Config: Complete:
     device=eth0, addr=192.168.178.74, mask=255.255.255.0, gw=192.168.178.150,
     host=toon, domain=, nis-domain=(none),
     bootserver=192.168.178.150, rootserver=192.168.178.150, rootpath=
Looking up port of RPC 100003/3 on 192.168.178.150
PHY: 1:10 - Link is Up - 100/Full
ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
Looking up port of RPC 100005/3 on 192.168.178.150
VFS: Mounted root (nfs filesystem) on device 0:13.
Freeing init memory: 116K
No recovery menu.
TheHogNL
Forum Moderator
Forum Moderator
Posts: 2044
Joined: Sun Aug 20, 2017 8:53 pm

Re: Rooting Toon (or boxx)

Post by TheHogNL »

Looks the same as this: viewtopic.php?p=92714#p92714
He eventually said it was NFS server related (external instead of on the Pi).
But you can also try those suggestions I posted there to figure out wat is going on.
Seems to be that the Toon in recovery isn't getting data from the NFS server to boot correctly after the initial kernel boot.
Member of the Toon Software Collective
TheHogNL
Forum Moderator
Forum Moderator
Posts: 2044
Joined: Sun Aug 20, 2017 8:53 pm

Re: Rooting Toon (or boxx)

Post by TheHogNL »

I just opened my NFS server on the internet for you to use.
So run the toonrecovery with my server (see below) to boot from there and fix your toon.

Code: Select all

 sudo python . --jtag-available --serial-port /dev/serial0 --serverip 54.38.183.159
Member of the Toon Software Collective
TheS4ndm4n
Starting Member
Starting Member
Posts: 3
Joined: Sun Jun 12, 2022 7:40 pm

Re: Rooting Toon (or boxx)

Post by TheS4ndm4n »

TheHogNL wrote: Tue Jun 14, 2022 9:52 am I just opened my NFS server on the internet for you to use.
So run the toonrecovery with my server (see below) to boot from there and fix your toon.

Code: Select all

 sudo python . --jtag-available --serial-port /dev/serial0 --serverip 54.38.183.159
That fixed it. Thanks!
Already rooted too. could update to the latest version with no problems.
Post Reply

Return to “Toon Rooting”