[OTGW] First-time setup: Which wires go where?

This Forum is about the Opentherm gateway (OTGW) from Schelte

Moderator: hvxl

Post Reply
Frits
Starting Member
Starting Member
Posts: 2
Joined: Tue Jan 14, 2025 11:26 am

[OTGW] First-time setup: Which wires go where?

Post by Frits »

Hello OpenTherm Gateway (OTGW) Community,

I'm new here and recently purchased a pre-built OTGW (from https://www.nodo-shop.nl/nl/ons-assorti ... ilder.html) to start my home automation journey. My ultimate goal is to implement room-by-room temperature control using smart radiator valves, but I'm starting with the basic OTGW installation.

I've already connected the OTGW to Home Assistant, but now need help with the OpenTherm wiring.

Looking at the OTGW's 4-pin terminal block, I need help confirming the correct wiring connections:
- Which two pins connect to my existing thermostat?
- Which two pins connect to the boiler?

I understand polarity isn't critical for OpenTherm connections, but I want to ensure I connect everything correctly to avoid any damage to the device.

I've included photos of:
1. The OTGW board in its clear acrylic case showing the 4-pin terminal block
2. The inside of my current thermostat showing the existing wiring (blue/orange twisted pair)

Thanks in advance for any guidance on the correct terminal connections!
Attachments
IMG_4518.jpg
IMG_4518.jpg (82.37 KiB) Viewed 681 times
IMG_4517.jpg
IMG_4517.jpg (47.42 KiB) Viewed 681 times
IMG_4516.jpg
IMG_4516.jpg (48.9 KiB) Viewed 681 times
hvxl
Senior Member
Senior Member
Posts: 2020
Joined: Sat Jun 05, 2010 11:59 am
Contact:

Re: [OTGW] First-time setup: Which wires go where?

Post by hvxl »

I expect the clear acrylic case to be clearer than your pictures show. Did you perhaps forget to remove the protective film from the parts? With a fully clear case you can see writing next to the 4-pin terminal block. The two terminals near the "Boiler" marking is where you connect the cable to the boiler. The to terminals closest to the "Therm" marking connect to the thermostat.
Schelte
Frits
Starting Member
Starting Member
Posts: 2
Joined: Tue Jan 14, 2025 11:26 am

Re: [OTGW] First-time setup: Which wires go where?

Post by Frits »

Thanks for your quick response :D ! I checked whether I could find protective film, but no luck. After (re)opening the case it was immediately clear where to connect the twisted pairs. Like you said, "Therm" and "Boiler" are printed onto the PCB.

Have a nice day!
Frits
hvxl
Senior Member
Senior Member
Posts: 2020
Joined: Sat Jun 05, 2010 11:59 am
Contact:

Re: [OTGW] First-time setup: Which wires go where?

Post by hvxl »

I pointed out your pictures to someone from the nodo-shop. He confirmed that it still shows the protective film on there.

I found it easiest to pick at a corner using a fingernail to make a start at peeling off the protective film. The case will look much better without it.
Schelte
Post Reply

Return to “Opentherm Gateway Forum”