IPPower HS log entries, I don't understand them?

Forum over de Homeseer IPPower plugin van Rene Klootwijk (DUTCH forum)

Moderator: Rene

Post Reply
olof
Member
Member
Posts: 281
Joined: Tue Aug 17, 2010 10:00 pm
Location: Netherlands

IPPower HS log entries, I don't understand them?

Post by olof »

I recently installed the IPPower 9212 & the HS plug-in in order to open/close my gate. It works, mostly, but there are several things I don't understand with the plug-in.

Perhaps anybody can help out?

1. What are all these DEBUG entries in my HS log? Did I configure something wrong? (please find enclosed various screenshots)
2. In order to keep my gate open, I need to re-run the HS Event Gate Open every 10 seconds. But this doesn't seem to happen. It runs again after 1 minute, but I have no idea where to look what the problem could be.

Thanks in advance for any help.
Cheers,
Olof
Attachments
HS log IPPower entries V2.jpg
HS log IPPower entries V2.jpg (126.96 KiB) Viewed 7295 times
IPPower event in HS II.jpg
IPPower event in HS II.jpg (63.5 KiB) Viewed 7295 times
IPPower event in HS.jpg
IPPower event in HS.jpg (54.16 KiB) Viewed 7295 times
IPPower status in HS.jpg
IPPower status in HS.jpg (263.11 KiB) Viewed 7295 times
IPPower plug-in config.jpg
IPPower plug-in config.jpg (94.46 KiB) Viewed 7295 times
IpPower pwd setting.jpg
IpPower pwd setting.jpg (79.44 KiB) Viewed 7295 times
olof
Member
Member
Posts: 281
Joined: Tue Aug 17, 2010 10:00 pm
Location: Netherlands

Re: IPPower HS log entries, I don't understand them?

Post by olof »

Well, now a few days later and I figured some things out....

:oops:

DEBUG entries in my Homeseer log are by choice. Within the IPPower Plugin settings, you can apparently set the level of info detail you want recorded in the HS log.
DEBUG is thus not an error message, but the most detailed level of log entries.

tja....
Olof
User avatar
Rene
Global Moderator
Global Moderator
Posts: 1689
Joined: Wed Oct 08, 2008 3:54 pm
Location: Netherlands

Re: IPPower HS log entries, I don't understand them?

Post by Rene »

The reason the state change is only noticed every 60 seconds is your configured refresh interval of the plugin. This interval can be configured in the plugin configuration page.
Rene.
olof
Member
Member
Posts: 281
Joined: Tue Aug 17, 2010 10:00 pm
Location: Netherlands

Re: IPPower HS log entries, I don't understand them?

Post by olof »

Rene,

Thanks for the reply. But to my, my setting looks like it refreshes every 30 seconds? (see 4th attachment)
Cheers,
Olof
Post Reply

Return to “Homeseer IPPower Plugin Forum”