I have update Windows XP to W7. I have also reinstalled a new HS2.
Now I have several MS13 devices which I don't know how to connect with HS2.
Has someone a short manual for me?
BR Wim
How to install a MS13
Re: How to install a MS13
It's not that difficult as far as I remember. I assume you have the RFXcom plugin and RFXcom receiver/transmitter in use?
If so,
just create an new device, with settings:
Name:
Room
Floor:
Device type: MS13 (hawkeye )
Have a letter code say F 3
Save this and go to the RFXcom tab.
Choose X10config
Now look for F (or any other letter you picked for your device) and change the "process" settings to Status Only"
save and have a look at the status update to find out if the device is noticed by Homeseer. That's it.
Wiechert
If so,
just create an new device, with settings:
Name:
Room
Floor:
Device type: MS13 (hawkeye )
Have a letter code say F 3
Save this and go to the RFXcom tab.
Choose X10config
Now look for F (or any other letter you picked for your device) and change the "process" settings to Status Only"
save and have a look at the status update to find out if the device is noticed by Homeseer. That's it.
Wiechert
-
- Advanced Member
- Posts: 718
- Joined: Wed Aug 12, 2009 1:42 pm
- Location: Eindhoven, Netherlands
Re: How to install a MS13
Thanks a lot.
I was looking in the RFXcom tab for creating the new device and couldn't find the right device type there.
B.R. Wim
I was looking in the RFXcom tab for creating the new device and couldn't find the right device type there.
B.R. Wim
-
- Advanced Member
- Posts: 718
- Joined: Wed Aug 12, 2009 1:42 pm
- Location: Eindhoven, Netherlands
Re: How to install a MS13
I think that you also need to add F 2 on the same way for the light-dark sensor of the same device.
B.R. Wim
B.R. Wim