Currently I have a humax settop box with ziggo. Works fine, I use plugwise to determine if it's on or off and a IR Trans to control it.
I don't really like it because it want to add more info about the device in my control panel. Also the control and onoff status is a bit flimsy.
I read about some decoder like the vu duo2 which can be connected through its Ethernet port. It sends statuses. I read some about this decoder. Its track record with ziggo isn't flawless. I'm looking for advice.
What are you guys using? Can you connect to it?
What do you use as settop box/reciever
What do you use as settop box/reciever
groeten,
Harry
Harry
Re: What do you use as settop box/reciever
i am using a dreambox 8000, it is a Linux based reciever so you can connect to it
and you can see more then that you pay for
and you can see more then that you pay for
-
- Member
- Posts: 86
- Joined: Sun Jun 03, 2012 3:08 pm
- Location: Apeldoorn / Netherlands
- Contact:
Re: What do you use as settop box/reciever
here an VU+ Ultimo (with OpenPli 4.0) and over webIF can control over network
Xtrusion Digital Home Automation Project
Re: What do you use as settop box/reciever
Haha. These where the expected ones! Do you guys have Ziggo by any chance?
Verstuurd vanaf mijn Nexus 5 met Tapatalk
Verstuurd vanaf mijn Nexus 5 met Tapatalk
groeten,
Harry
Harry
-
- Member
- Posts: 86
- Joined: Sun Jun 03, 2012 3:08 pm
- Location: Apeldoorn / Netherlands
- Contact:
Re: What do you use as settop box/reciever
here it's UPC network, but VU+ can have up to 3 tuner modules inside for DVB-C so should support ziggo cable too
Xtrusion Digital Home Automation Project
Re: What do you use as settop box/reciever
I've looked into the openpli forum. It looks Ziggo will work. But without interactive TV (no biggy). Nobody got the Ethernet port of the Cisco or humax working?
Verstuurd vanaf mijn Nexus 5 met Tapatalk
Verstuurd vanaf mijn Nexus 5 met Tapatalk
groeten,
Harry
Harry