Flash PIC 16F88 error - firmware 5.2

This Forum is about the Opentherm gateway (OTGW) from Schelte

Moderator: hvxl

Post Reply
Jerby
Starting Member
Starting Member
Posts: 1
Joined: Sun Jan 30, 2022 7:19 pm

Flash PIC 16F88 error - firmware 5.2

Post by Jerby »

I tried to upgrade the OTGW firmware from version 5.1 to 5.2. First via OTmonitor but that failed. Then I tried it with ArdPicProgHost.exe and an Arduino. The first part looks Ok but at the last addresses (0F80) it fails and reports "Write error to device - Please erase device first!". See screenshot. But when I Erase the PIC first (as shown on the screenshot) I get the same error. What to do?
PIC programming error v1.8.jpg
PIC programming error v1.8.jpg (151.7 KiB) Viewed 999 times
hvxl
Senior Member
Senior Member
Posts: 1965
Joined: Sat Jun 05, 2010 11:59 am
Contact:

Re: Flash PIC 16F88 error - firmware 5.2

Post by hvxl »

This seems to be a question about the particular PIC programmer you're using, rather than the OTGW itself. This forum is probably not the best place to get an answer to such questions. If you had asked about the upgrade via OTmonitor, that would have been more on topic. But by using the PIC programmer you have probably destroyed that option.
Schelte
Post Reply

Return to “Opentherm Gateway Forum”