Page 2 of 2

Re: Aeon Labs controle module via RS32 possible

Posted: Sun Jan 02, 2011 7:25 pm
by Edwin2008
@mhn.
How did you open the z stick? After first doing some testing (see how zwave works and how the stick works) i'm planning on creating a rs232 connection to the stick. The idea is to open the stick and make a flatwire connection to a rj45 plug and then close the stick again so it will look neat and gives me also the posibilitie to connect and disconnect nodes.

Re: Aeon Labs controle module via RS32 possible

Posted: Sun Jan 02, 2011 8:08 pm
by mhn
@Edwin2008

Just press a nail or small flat screwdriver along the joint at the sides. Mine has been opened a couple of times, and still look nice.

But be careful, the clasps are fragile. :-)

Regards
Morten

Re: Aeon Labs controle module via RS32 possible

Posted: Sun Jan 02, 2011 8:24 pm
by Edwin2008
got it, that was pretty easy if you now where to press. Thanks!