Page 1 of 1
Visonic Powermax + configuration in HS
Posted: Sat Feb 07, 2009 4:08 pm
by Ren
Homeseer is working proparly at the moment and my Visonic sensors are visible in HS (Thank you Maarten).
Next move is to arm and disarm my Powermax. Can someone with the same equipment guide me during this proces?
You can add me at
waypoint99@msn.com
Rene
Visonic Powermax + configuration in HS
Posted: Sun Feb 08, 2009 8:43 pm
by Nielsy
That would be very nice,
I'm also intressed in "remote" arm and disarm a visonic system.
Could that trough RS232 of X10 ? Would somebody know?? en how? or know the commands...?
Visonic Powermax + configuration in HS
Posted: Sun Feb 08, 2009 9:52 pm
by TANE
You can modify the keyfob by adding two wires and connect this to the UM7206
UM7206 can be controlled via HA
I'm going to do that only for Arm command.
Be sure that you place the keyfob somewhere that the intruders can't find it in few seconds.
Visonic Powermax + configuration in HS
Posted: Sun Feb 08, 2009 10:56 pm
by Ren
Its only for the commands to arm and disarm my PM+. Correct me if I'm wrong but would a XM10 interface to communicate between HS and my Visonic be sufficient also?
Rene
Visonic Powermax + configuration in HS
Posted: Sun Feb 08, 2009 11:00 pm
by TANE
ARM command is okay..you can do that from HS when you modify the Keyfob.
Disarm will also work but a bit risky
Visonic Powermax + configuration in HS
Posted: Mon Feb 09, 2009 12:16 am
by Rene
The only method to give the Powermax commands without using the console or a keyfob is by using Powerlink. It would be interesting to known how the Powerlink module interfaces with the Powermax so we could use this type of interface to issue commands from within Homeseer.
Rene.