Page 1 of 1

Merten 507900 / ZCU201 USB Interface Z-Wave

Posted: Sat Nov 07, 2009 6:18 pm
by jakkes
I have the stuff as mentioned above.

In Homeseer the USB Interface is seen correctly on Com7

So now i want to add the merten to HS.
Should it be done with "Manage" and then "import Devices"?

I get this message:

Loading network information from your Z-Wave interface... Done.
Synchronizing network information against HomeSeer devices...
No nodes were found in the Z-Wave interface.
Finished with Z-Wave device synchronization.

Merten 507900 / ZCU201 USB Interface Z-Wave

Posted: Wed Nov 11, 2009 1:03 pm
by jakkes
Is there someone who can tell me how to add Z-wave devices to HomeSeer....

Merten 507900 / ZCU201 USB Interface Z-Wave

Posted: Mon Nov 16, 2009 8:54 pm
by Wim2008
First start with upgrading Homeseer to version 2.4.0.1. Gives better support with zwave and devices.

Second you have to import de Merten products on the usb-stick.
- Close homeseer and get out the usb-stick.
- Go to you Merten unit and import it on the usb-stick.
- Put your stick back in your pc and start homeseer again.
- Now import devices.

B.R. Wim [:)] [;)]