Home Automation Domotica Forum Europe, Bwired Forum

Hi,

I have sinds a short month that when HS is running for about 1 week that HS is getting for about 60 to 70% usage of my CPU.
I have not change anything that can be the problem, so my question what is the best way to resolve this problem?

Regards,

DJ,

Have the same problem, but i do know the cause at my place: polling the zwave modules.

Do you use the PHNetwork plugin?

I've had also high cpu, this was also because of polling z-wave devices. If i poll all my devices the events just wont run correctly anymore (lights jump on after 5 seconds instead of almost instantly when motion is detected)

I have Z-wave but i'm polling every 60sec. at this moment so i think this can not be the problem.

But i have running PHNetwork so what can i do to solved it (ok disable the plugin only that is not the sollution)

btw, at the moment when it polls all the devices.. if you have a motion z-wave device for instance going through homeseer, it will be slow/annoying delays.. dont know if they will fix that though.

i also once had some debugging still turned on, which created something like 400gb of text data cant remember which one it was (but you can check your homeseer folder to look for big files)

djdive wrote: But i have running PHNetwork so what can i do to solved it (ok disable the plugin only that is not the sollution)

I don't have these problems with PHNetwork but I know some forum members do.
When you disable the plugin for some days and you see no high CPU usage anymore you can assume the plugin is causing the problem. Then you at least know that the plugin is the problem...