Home Automation Domotica Forum Europe, Bwired Forum

Hi,

I have an older rfxcom receiver. Now rrfxcom receiver the modes are different. I wnat to set my older rfxcom receiver in the same mode as the rfxcom receiver today are sold.

I have this, what is missing

2011.01.16 22:24:07 1: RFXCOM: RFXCOM_OpenDev /dev/ttyUSB0 done
2011.01.16 22:24:07 3: RFXCOM: device opened
2011.01.16 22:24:08 1: RFXCOM: Init version master=18, slave=
2011.01.16 22:24:09 1: RFXCOM: Init variable length mode OK
2011.01.16 22:24:10 1: RFXCOM: Init all receiving modes OK (hex=2c)

regards Richard

I want to know he codes, to come into the same mode as firmware 50 default, I have firmaware 18

so enable all f02a? etc

regards Richard

Almost all mode setting commands are the same in all receiver versions.
Check the available commands in your receiver documention on the RFXCOM CD.

Enable All RF = F02A
RFXCOM - Variable length mode is F02C