Re: How to run PMIX35 software under windows / ultimate
Posted: Wed Aug 31, 2016 2:38 pm
PMIX35 works fine for me for years already, some notes:
- Use driver 6.6.1 (instead of 4.4 I saw mentioned above)
- When trying to send a command and seeing the led blink, but the device is not affected, often this is a issue around voltage.
PMIX35 does reset the voltage level to 0 sometimes when power is lost. Manually set the voltage to 5 volt solves this issue.
- Missing packets with the PMIX35 should not be possible because the buffer is caching all incoming signals.
Make sure the buffer is not full by setting the poll time correctly.
- Use driver 6.6.1 (instead of 4.4 I saw mentioned above)
- When trying to send a command and seeing the led blink, but the device is not affected, often this is a issue around voltage.
PMIX35 does reset the voltage level to 0 sometimes when power is lost. Manually set the voltage to 5 volt solves this issue.
- Missing packets with the PMIX35 should not be possible because the buffer is caching all incoming signals.
Make sure the buffer is not full by setting the poll time correctly.