Home Automation Domotica Forum Europe, Bwired Forum

This week I got a GatewayOT inside.
This I now flash the correct firmware. I want it gateway.hex flash but I get this error message: "Please manually reset the Open Therm Gateway"

What can I do to fix this? Like asked for help.

Chriskras wrote:This week I got a GatewayOT inside.
This I now flash the correct firmware. I want it gateway.hex flash but I get this error message: "Please manually reset the Open Therm Gateway"
What can I do to fix this? Like asked for help.

Did you try powering off and on the OTGW at that moment? Because it's not really an error but a command (for the user). You need to power cycle the OTGW for the upload to start.

Solved my problem was that all of the RS232 connectors were not connected. So here I soldered it again.