Page 1 of 1
How to install a MS13
Posted: Thu May 08, 2014 3:16 pm
by Wim2008
I have update Windows XP to W7. I have also reinstalled a new HS2.
Now I have several MS13 devices which I don't know how to connect with HS2.
Has someone a short manual for me?
BR Wim
Re: How to install a MS13
Posted: Thu May 08, 2014 3:59 pm
by mrqnapper
It's not that difficult as far as I remember. I assume you have the RFXcom plugin and RFXcom receiver/transmitter in use?
If so,
just create an new device, with settings:
Name:
Room
Floor:
Device type: MS13 (hawkeye )
Have a letter code say F 3
Save this and go to the RFXcom tab.
Choose X10config
Now look for F (or any other letter you picked for your device) and change the "process" settings to Status Only"
save and have a look at the status update to find out if the device is noticed by Homeseer. That's it.
Wiechert
Re: How to install a MS13
Posted: Thu May 08, 2014 7:08 pm
by Wim2008
Thanks a lot.
I was looking in the RFXcom tab for creating the new device and couldn't find the right device type there.
B.R. Wim
Re: How to install a MS13
Posted: Thu May 08, 2014 9:05 pm
by Wim2008
I think that you also need to add F 2 on the same way for the light-dark sensor of the same device.
B.R. Wim