Harrison Neta12 curtain system

[Francois]

Two questions on the status updates and sensors:
1. Are they fast enough to facilitate a "half open scenario" What I mean is: send open command --> sensors halfway the rail is triggered --> send stop"
2. What interface do you use for z-wave to Homeseer?

[TANE]

My curtains are offline because of renovation in my house.

I´m going to use zwave sensors Everspring SM103.
Zwave sensors will be placed at the stop point of the curtains.
magnetic part will be mounted at the moving part

When curtain is open sensor will be closed and I will send a status update to Harrisson.
When curtain is closed sensor will be open and status update closed will be send.
Update of the status will be done via events.

Some controlling events will be also build to be sure that the send command did work well.
When close command is send to Harrison and the curtain is still open I will resend the command again.
When the remote is used for controlling the status will be updated via the sensor.

[Esteban]

Visonic sensors will be fine
http://www.visonic.com/Products/PowerG- ... mc-302-pg2

Are you sure you mean the MC-302-PG2 (PowerG), not the MCT-302 (PowerCode)?

[TANE]

correct...is the normaal Visonic MCT-302

[Alexander]

Harrison will almost never mis any command from rfxcom.
In the last three years maybe just 2 time.
I'm also going to add sensors to harrison since I want to now the status.
Some of the curtains are closed manually..Rfxcom will not update the status when the Harrison remote is used for the control.

I thought it was Bert that suggested a time ago to set a different address on the remotes, to trigger a homeseer event that send signals to the curtains on a different address than the remotes. Than the update status within HS will change. Nevertheless, non checks ofcourse.

[TANE]

Did't know that the Harrison remote is recognized in rfxcom...

[Alexander]

Found the related topic: http://domoticaforum.eu/viewtopic.php?f=27&t=1726