Home Automation Domotica Forum Europe, Bwired Forum

Hi,

I don't know if it is the good forum to post support for RFXTrx433, but I bought this Led controller
http://eud.dx.com/product/432w-wireless ... L9l2iuG8Ro

I cannot see the signal even with Type 1 and 2 firmaware, and Lightwave/AC or Lighting 4 protocl enabled.
There is an id written on the device and I try to send signal with Rfx manager, but I'm not sure that I put the right ID.
My ID is like 12345 (5 digit), so I put it like this in Rfx Manager : 01 23 45
Is it right?

Is there another way to catch signal or test emmiting?

Thank you very much

This device is not supported by the RFXtrx433(E)

See chapter 2.2.2 in the RFXtrx User Guide for the list of supported devices!
Supported are:
RGB LED strip driver dx.com
- http://www.dx.com/ order nbr: 130913, 67412
receiving of the 2 battery remote is only supported in Type2 firmware and is used to get the RGB remote ID.

Ok.
My fault : I'd see the same remote, so I supposed it's compatible.

Is there a future possibility that it will be compatible? (In future FW upgrade?) or not?


Thank you