RFXCOM - Visonic Keyfob MCT-237

Post by **Paul** » Fri Jan 30, 2009 1:56 am

Hi,
I'm playing around with this stuff, and it seems to me that I'm having a bit of a problem receiving events for all the buttons in Homeseer.
I'm not too familiar with this stuff yet. Is this my mistake or could it be a request for next version of plugin?
I got the RFXCOM receiver connected to HomeSeer via the RFXCOM plugin and would like the HomeSeer to react to the two "extra" A and B buttons on the MCT-237 keyfob.
Can't see anything in the log, and the debug log did'nt make much sense to me.
Am I missing something here?

Was hoping to be able to use those for locking and unlocking my door.

Regards,
Paul

Post by **Rene** » Fri Jan 30, 2009 11:33 am

RFXCOM misses the signals from the keyfobs on a regular basis. Something to do with the encryption used. A better option is to connect your Powermax via a XM10 to the powerline and configure it to send an X10 signal when the A or B button is pressed. This is described in the manual.

Rene.